Mounting Hardware
PRP seats come with four vertical tabs, one in each corner on the bottom of the seat. On our standard width Premier Seats and Competition Seats the tabs are 14" from side to side and 18" from front to back. We offer the following products to help you mount your new PRP seats
Weld these tabs directly to your roll cage and solid mount your PRP Seats using 7/16 hardware. These 3/16" tabs are the thickest in the industry.
Mounts for Jeep TJ for the years 1997 to 2002
Mounting hardware for 2003 - 2006 Jeep TJ.
Hardware to mount Polaris Ranger Front Bench
Mounting hardware for Polaris Ranger Rear Bench
Mounting hardware for your Rhino seats.
Mounting hardware for yoru Teyrx seat.
Designed to mount to a flat surface and raise your seat 6 inches off the floorboards. Originally intended for use in a VW Bugs or Manx style buggies. They can be used wherever you have a flat mounting surface. The sliders provide 7" of movement.
Normally used on the passenger side of a vehicle to allow access to the back seat. This will mount to a flat surface and lifts the seat mounts 6 inches off the floorboards.
The same design as our Slider Mounts however they are only 2.5" tall.
We also make these 2" narrower for the PRP Roadster seats.